The way to Replace a Sensor at a Yard Light

Using lawn lights which have solar technologies lets you position fixtures in just about any location since you do not have to be worried about electric wiring connections. Each of these lights is automatically illuminated by its inner photocell; this detector detects ambient light and turns the fixture on when nighttime arrives. The light’s electronics, however, fail periodically. Subsequently, the lawn light won’t illuminate at the correct time or may flicker erratically. Replacing the detector typically requires using basic, hand-operated tools to protect against an expensive repair phone from a specialist.

Turn the light head on the mounting bet by hand. Pull the light head from the mounting bet. Place the light head to a work surface. Depending on the light maker’s design, the light head may be threaded to the mounting bet or simply locked on by a grooved connector.

Locate the screws which hold the light head’s top and bottom assemblies with them. The screws are on the mild head’s bottom, which offers protection from rain.

Detach the screws from the light head by using a screwdriver. Consult with the lighting’s owner’s manual for the particular screw types used, if needed, to determine the kind of screwdriver to use; coats differ among light designs.

Pull the light head’s top and bottom housings apart carefully by hand. Lay each casing on the work surface.

Locate the photocell detector on the top casing. Typically it is near the solar panel so it is subjected to ambient light. Remove the screws holding the photocell detector to the casing by using a screwdriver.

Adhere to the sensor’s wiring to its connection point visually. Pull the sensor’s wire connector from the attachment point on the casing by hand. Eliminate the entire detector from the lawn light.

Position a brand new sensor at the upper housing. Reconnect the sensor’s wire connector to the housing’s attachment point. Reattach the screws to the sensor’s mounting holes with a screwdriver.

Press the top and bottom housings back with them. Visually inspect the connection point to verify that no wires are pinched between the housings.

Reattach the housing’s screws with a screwdriver.

Secure the light head back to the mounting bet. Permit the lawn light to remain idle during daylight hours.

Observe the lawn light when dusk arrives. Verify that the light illuminates when nighttime begins. If it doesn’t, repeat the procedure for replacing the detector.

See related